The maintenance and overhaul of ceramic ball mill is a regular work, maintenance work is good or bad directly affect the operation rate of ceramics ball mill and service life, in order to discover the defect and eliminate the hidden trouble, in order to ensure the normal operation of ceramics ball mill, in addition to the daily maintenance, also need to regularly stop grinding, (recommended once a month) on important components such as hollow shaft, main bearing, cylinder, reducer, such as the size of the gear carefully check, make a detailed record, according to the defect of priorities for appropriate processing and arrangement of long and overhaul plan. So how to correctly maintain and overhaul ceramics ball mill?

1, all the lubricating oil in ceramics ball mill put into continuous operation should be all sent out a month, thoroughly clean, replace the new oil.After repairing combination about once every six months in the oil.

2, all lubricating points lubrication condition and check the oil level height at least every 4 hours at a time.

3, when ball mills operation, main bearing lubricating oil temperature is not more than 55 ℃.

4, mill run properly, the drive bearing and the rise of temperature of the reducer is not more than 55 ℃, the highest do not exceed 60 ℃.

5, big and small gear transmission is smooth, no abnormal noise.When necessary, should timely adjust the clearance.

6, ball mill running smoothly, without strong shock.

7, motor current should be no abnormal fluctuations.

8, each connecting fastener no looseness, no oil leaking in the joint surface, five evasion, no water leakage phenomenon.

9, steel ball wear in accordance with the situation in a timely manner to add.

10, if found abnormal situation should immediately stop grinding repair.

11, ball mills liner wear 70% or 70 mm long crack should be replaced.

12, plate bolt looseness caused damage of lining plate should be replaced.

13, main bearing severe wear should be replaced.

14, ceramics ball mill perforated strainer plate wear into stoppage time can't welding should be replaced.

15, after the big gear gear surface wear to a certain degree may continue to use flip.

And we also have other mining machines, such as spiral classifier, granite crusher and gravity spiral chute and so on. If you have any other question or have an interest on our product ,you can write to us: .

agitation flotation machine: http://www.ore-processingplant.com/ore-beneficiation-equipment/agitation-flotation-machine.html