Scrap metal crusher machine is necessary mechanical equipment of scrap metal recovery, which can greatly reduce labor cost. Generally speaking, a scrap metal crusher machine requires only one person to operate, which can greatly improve efficiency of metal recycling. Metal Crusher is the latest type crusher which is produced according to the requirements of the market by dafu machine, who organize the power and combine the specific practical application of the clients from home and abroad. It is very high-efficiency, energy-saving. But the metal crusher may have some problems sometimes. And do u know how to handle with the problems of scrap metal crusher machine?

Metal crusher work in one of the most important is the inside of the fan and the rotor, although is a widget is a bad soon, the following is a fault and the solution for scrap metal crusher:

1. The metal crusher will take a long time when the inside of the bearing excessive wear, caused by the friction between stator iron core surface damage, can cause a short-circuit motor iron loss increase so that the temperature of the motor, immediately with smooth file tools to remove the burr, clean off between silicon steel sheet sub clean smear insulating paint again after the last heating drying.

2. If the force of metal crusher is too large, need to dismantle the winding stolen slot will skew or outward open, long nose pliers, wooden hammer at this time should be used the repair tools to repair, scrap metal crusher can make the tooth back in situ, at the same time also to be in a bad place and there is gap between silicon steel sheet in plus insulation board of the green shell paper, glue.

3. Sometimes because of the weather reason at this time of the core surface have rust need to get a sandpaper clear rust.

4. One is to remove the iron core is burnt again or tooth department also have to chisel or above scraper can be cleared away, also after the clearing in bruises insulators and drying.

5. Found loose time frame and core need immediate fixed screw, if the screw failure can also stand on drilling in the fixed screw again.

If you have any other question or have an interest on our product ,you can write to us: .

compound fertilizer production machinery: http://www.chinaftm.com/news/n595.html